Home / Tag "Woodworking" (Page 8)

Belting up

Japanese ToolboxLockerTools
More
Woodworking

A few hours in the shed today that felt productive (it’s a false positive; it was just that a few end stages happened at the same time). Started off with the final fettling of the carcass for the locker and then smoothed all the interior surfaces and rounded the corners I won’t be able to readily reach after glueup.

20 minutes with #04 and card scraper and we’re ready to glue up.

Prepped an mdf surface to assemble on…

Final dry run…

Okay, looks good, knock it apart and start the glue-up.

Mise en place is as important in woodworking as it is in the kitchen…

And that’s the carcass glued up and left to cure (the back’s not glued on yet).

Then it was time to fix the bandsaw.… Read the rest

Read More
Mark Dennehy in No Comments

Fettling

LockerWoodworking

So the repair job from yesterday went reasonably well. There’s a lot of excess CA to clean up, that took a few minutes for the face side, and a bit longer for inside the rebate itself. Lots of chisel work, some scraping, and dug out the Record 311 with the nose off and the 077 to fettle things and clean up the rabbet to get a square inside corner. Then cut the rabbet on the other side wall, which took far less time and had no drama to it, then cut the rebate in the top piece and then test fitted it and realised my mistake – by cutting the rebate in the top, I’d introduced a gap where I thought there wouldn’t be one. How I didn’t see that coming I don’t know.… Read the rest

Read More
Mark Dennehy in No Comments

Splitting rabbets

LockerWoodworking

So, another housing joint to chop…

Giving the new chisel mallet a workout. So far, it’s working very well. Chopped the housing joints as per yesterday (had to take a pause to take the #08 to the edges in the vice, I’d missed a small bow in the edge so I wanted to correct that before marking out for the new joint).

All grand. Did a test assembly and everything fitted and was square. Excellent. Then thought about the back and decided to rebate it in, but with a stopped rebate (the client 😀 doesn’t want the back to extend all the way to the ground), so marked out for that and got out the #778 and suddenly realised that on one side (and of course, the side I’m starting on), the #778 is the wrong handedness.… Read the rest

Read More
Mark Dennehy in 3 Comments