walnut – Page 13 – Stochastic Geometry

Home / Tag "walnut" (Page 13)

More small jobs and practice…

All small jobs today in the shed. Well. Was a bit chilly.

And it was colder before I turned on the heater. Not going to get much better before the end of next week either 🙁 Onwards…

Got my new japanese saw bench hook finished:

Spare offcuts of walnut and plywood, with 19mm dowels from woodies (if you’re in the US, woodies is what Lowe’s would be if they dropped their timber standards significantly and jacked up their prices by 50%). The dowels drop into the bench dog holes:

In theory this would work on any set of two holes, but it turns out there’s just enough variation in spacing that it only works for this pair 🙁 Next time I build a workbench, I’ll be a lot more precise with a few things and dog hole placement is one of them.… Read the rest

Mark Dennehy in 05 Jan 2018 No Comments

Done…

Bandsaw Boxes Desk Shelf Finishing

Wall Cupboard Woodworking

Next year, we’re rescheduling christmas. End of discussion.

This year, Christmas Eve started with a quick run to woodies for small brass hinges. Then to the shed and…

Awkward planing setup needed to plane the outside of the carcass (the inside was planed before glue-up). I know it doesn’t look too awkward, but that’s because we need to zoom out a little and let you see where you’re standing when working…

The spot is that one there behind that small green case on the floor, between the bench and the tumbledrier but not past the leg of the bench because there’s a lot of small boards there that didn’t go in the main wood store. The joy of a small shed…

The downside is that you can’t really move when planing, so it’s all armwork rather than legwork.… Read the rest

Mark Dennehy in 26 Dec 2017 2 Comments

Nyaaaarrrrrrggggghhhhh….

Bandsaw Boxes Wall Cupboard Woodworking

Seriously, who timed this christmas lark? It’s supposed to be January 6 for feck’s sakes…

Getting better at these. Only three of the four joints look like a blind boy scout attacked them with a dull beaver…

But they go together…

And the carcass is square. Grand. Only sixty more steps to go. Hide glue, btw. Set aside to cure for most of the day. then planed the face side so it was all in plane and with no twist. Then went to nail on the face frames and discovered I’d resawn them down to use as back boards. For feck’s sakes…

And no, it won’t work when the face frames are thinner than the door because then the hinges won’t work (and there’s not enough thickness to even attach them anyways)
I did find another poplar stick I can use, so it’s recoverable but I’m not loving when this happens.… Read the rest

Mark Dennehy in 24 Dec 2017 No Comments