Home / Tag "tools" (Page 4)

Bandjaxed

Japanese ToolboxLockerTools
More
Woodworking

So it’s a bank holiday weekend and I was looking forward to lots of time in the shed, but on friday a nice lady held me down and shoved a screwdriver and a pair of pliers in my mouth so I wasn’t really up to much woodworking on the Saturday, but at least the extraction didn’t cause too much pain after the fact so today I decided to hit the shed and get on with some stuff, and I thought I’d start with some resawing.

The fence they ship the Titan bandsaw with is ridiculously awful, so this is what I normally use – just a length of extruded aluminum that normally serves as a straightedge when planing. I must see about getting a wider box section for this job though, the underside of the table has ribs so it’s not so easy to find a flat spot to get the clamps on without tipping the fence over when you clamp.… Read the rest

Read More
Mark Dennehy in 6 Comments

A busy weekend…

Japanese ToolboxToolsWoodworking

…and almost none of it spent in the shed, but for once that wasn’t a bad thing 🙂

(I know this might be confusing if you’re reading this outside Ireland, but check the international news, we wound up in it almost everywhere). Herself was canvassing and leafletting and doing her part for this for the last few weeks, and we were all a bit on edge throughout because the No campaign were being violent and abusive and just plain nasty in an attempt to drive down turnout for the vote, but in the end people remembered thirty-five years of suffering and overwhelmingly voted yes. After which, to be frank, we were all a bit weepy and wiped out. Herself went in to Dublin Castle for the official announcement, and I went off with Junior to the grandparents to decompress and grill some hamburgers, and we all went home and crashed that evening with a plan to not even move the next day if we didn’t have to.… Read the rest

Read More
Mark Dennehy in 3 Comments

Pottering about

ShedToolsWoodworking

Last project finished, next one not properly started yet (just have the rough cuts done) and another in mind but not off the notepad yet. So now’s the time to work on the shed itself…

That’s the dust collection for the shed (it’s collapsed because the vacuum hose got clogged with shavings and the shop vac managed to pull enough air out of the barrel for atmospheric pressure to crush it). It’s a bit… big. For the shed at least. So a while back, I got a smaller drum.

And it’s been sitting there since I bought it, getting in the way, because I was trying to get other stuff done. So…

Out with the old…

And mark out and measure for the minicyclone seperator in the lid of the new drum, cut out the large hole with, of all things, the lie-nielsen radius cutter I was using for stringing on the last project, and then drill the holes for the attachment screw and fit it.… Read the rest

Read More
Mark Dennehy in No Comments