Home / Tag "tools" (Page 15)

Getting technical

ShedSidecar CotWoodworking

So this:

is a shooting board (this one’s from Popular Woodworking, mine’s not as neat). Idea’s simple – for thinish boards (once you get up to an inch thick, you start just holding it in the vice and running a block or bench plane across it), you feed the board into the plane which is on its side and it will true up the end so it’s exactly 90 degrees to both faces and edges. Which is handy for making things that don’t look like they were drawn by Escher while drunk. Problem is, most of my planes don’t have big sides – they’re the traditional bailey pattern and have rounded cheeks:

Which works, but it is a bit tippy. And the sides aren’t quite 90 degrees to the sole either, they’re a degree or so off.… Read the rest

Read More
Mark Dennehy in No Comments

That whooshing noise…

FinishingSidecar CotWoodworking

…is a rapidly approaching deadline 😀 So there’s been a lot of work and not a lot of photos and typing.

I’ve been testing some finishes…

So there’s shellac on the walnut, I’m testing both shellac and osmo wax on the ash, and milk paint on the poplar. The latter is very vibrant going on…

…but after it’s dried the next day, it’s faded a bit…

…which is disappointing, because I’m not a fan of this modern shabby chic chalk paint nonsense. But if you put a layer or two of osmo over the top of it, it picks back up somewhat. Well, it’ll have to do.

Meanwhile, all the panels are now planed (holy carp but kiln-dried ash is god-awful stuff to work with even if it does look nice, especially long heavy pieces), all the frame pieces are cut to length and we’re into the joinery and fitting stage.… Read the rest

Read More
Mark Dennehy in No Comments

Tool night

ShedSidecar CotWoodworking

Holidays started, and a couple of new tools showed up in the post (well, rutlands was having a black friday sale and some nice things popped up on ebay for decent prices).

A few fairly cheap rasps. Machine-made, no hand-stitched french rasps in my budget for a while (these cost about twenty euro for the set, a single hand-stitched one would cost a little over a hundred euro more than that). Might be useful for the curved parts of the crib when I’m finishing them.

One of these dividers is new; one of these is older than the modern state of Ireland. And they both work pretty damn well. (They’re for laying out the dovetails in the drawer of the crib).

I kept having to set and reset my existing veritas gauge using scraps of wood with the gauge lines in them (which works great until you drop the scrap down behind the workbench where it’s bloody awkward to get to), then I noticed that other people got round this by having a small army of the things and using different ones for different measurements during a project (no you can’t set them off a ruler, you’ll inevitably get parallax error setting it and make a mistake that shows up glaringly later on).… Read the rest

Read More
Mark Dennehy in No Comments