Home / Tag "tools" (Page 10)

Progress and mucking about

GeneralSide TableTools
More
Woodworking

So I figured I’d start by playing with the new toy and taking some test cuts.

The blade runs sort-of true. Well, I wasn’t expecting laser levels of perfection here, but the guides really are letting things down. The lower thrust bearing can’t be backed off readily to adjust it so it’s not poking the blade out of true, which is disappointing. And I really can’t run this thing without dust extraction or the whole lower case clogs up and the bearing itself locks up. Well, I knew machinery would counter its speed by increasing the amount of faffing about needed to support it. This is why you usually mount this stuff permanently where you have room to manoeuvre around it. But again, 8’x6′ shed, no room to think, let alone manoeuvre, so we need to make do.… Read the rest

Read More
Mark Dennehy in No Comments

Interloper

New Toys!ShedTools
More
Woodworking

So it’s pretty obvious that all my woodworking stuff is done with hand tools, right?

It’s not because of an ideology, it’s because 8’x6′ sheds don’t give you a lot of room for power tools or machinery. I do find the power tools really obnoxiously loud, but that’s a secondary point and it’s mainly because the cheap modern power tools tend to use lightweight construction and universal motors in order to hit a price point and so make a lot of high-pitched noise — older stuff with induction motors and a lot of cast iron are a lot less screechy (you definitely do need hearing protection anyway, but for the neighbours it’s a significant qualitative difference).

And for some things – joinery, shaping, finishing and so on – it’s more of a challenge to use hand tools and so more satisfying to do.… Read the rest

Read More
Mark Dennehy in 1 Comment

Scraping by…

ShedWoodworking

Part of the tidy-up in the shed meant getting the scrapers off the little holder they were in and up on the wall…

And then the second thing was going through every single plane and chisel on the wall, going over all the unpainted parts with 600 grit wet&dry paper and WD40 to take off the surface rust, then rubbing briwax into the steel as a barrier against rust (renaissance wax would be better and some’s on the way). I’ll have to do this every weekend for a while to get the barrier layer set up properly.

I hate condensation. Gah.

There may be a dehumidifier in the shed’s future.… Read the rest

Read More
Mark Dennehy in No Comments