oak – Page 6 – Stochastic Geometry

Home / Tag "oak" (Page 6)

So the resin tests came out pretty damn good. The idea of putting the reflector under the resin worked quite well, and most of the colours came out well (the crimson guitars stains didn’t really pop but that was more down to the dark background – the way the red especially looked over the reflector suggests it’d be lovely over poplar).

Calum picked out a few he liked as well (the ones with crosses beside them in pen). So now I’m just picking out designs to do for the various parts of the desk, shelves and sides. I need to print a few out and find some transfer paper, then some will be done by inlay and some with resin and some with a mix.… Read the rest

Mark Dennehy in 24 Feb 2019 No Comments

Fettling

Baby blanket chest Desk Shelf Tools

Woodcarving Woodworking

More shed time today, and I spent the first half of it fettling the middle shelf in the desk. Straightforward, if repetitive process – assemble, check what’s too tight and what’s too loose, cut or pare the shelf a little narrower with saw and chisel, reassemble, recheck, repeat until the dovetail joint that was horribly stressed by the shelf being too wide:

…is no longer stressed, but just snug:

And doublecheck all the other joints to be sure nothing else is opening up.

Okay, I’m happy with that.

I’m also happy because before assembling this, I marked out the back of the top of the sides to show which bits had to be cut off to give a straight line across the back (because the top goes up against the wall for support), and when I assembled it:

Nice straight line.… Read the rest

Mark Dennehy in 17 Feb 2019 No Comments

Groovin’ tools

Stringing Tools Woodworking

So the last try to make a straight line cutter for stringing didn’t work so well, the fence mortice was too sloppy. So today I cut a new one. Simple process; pick a scrap of wood from the bin (in this case a piece of walnut because I’m not averse to cheating when it comes to mortices 😀 ). I’ll reuse the beam so I mark off a line on the fence with a square, drop one edge of the beam into it and then mark the width off on the fence and carry the line around with a square; mark top and bottom of the beam with a wheel gauge using the same reference face you used for the square, and that gives you the outline of the beam on the front and back of the fence and aligned.… Read the rest

Mark Dennehy in 26 Mar 2018 2 Comments

Stochastic Geometry

mark.dennehy

Resin results and carving again

Fettling

Groovin’ tools