oak – Page 13 – Stochastic Geometry

Home / Tag "oak" (Page 13)

Last few days have been the first really cold ones of the year. -2C to -3C in the shed. And work was… somewhat excessive in the last few days so tonight was the first time in the shed in a few days and a to-do list was waiting. So…

Ran a slightly larger drillbit through the aprons to give some flex room for the bolts, and flattened the top of the aprons (I also spent a half-hour before this with the scrub plane and #5 flattening the underneath of the tabletop and hand-cutting the panel to width to trim out the worst of the bandsaw wobble).

The stainless steel inserts arrived on Thursday in the post, thankfully. Seems everyone makes these in zinc-plated steel, but actual stainless is a bit hard to find.… Read the rest

Mark Dennehy in 10 Dec 2017 No Comments

Resawing sucks.

Baby blanket chest Woodworking

Honestly, if there is a better argument out there for buying a large bandsaw I haven’t heard it yet.

Yes, I’ve heard of roubo frame saws. My shed hasn’t enough room between the face vice and the wall to use one.

Yes, I have western hand saws. I either need to resharpen them or recut their teeth because the best one I have didn’t want to cut.

Yes I have a bandsaw already – it can’t resaw anything over 75mm. That there is 115mm.

So, wax blade, yank handle, shove handle, repeat till ticked off enough to pull board halves apart by brute force, plane off worst of the gack in the middle with scrub plane, give outside a few passes to mitigate uneven drying, repeat.

What, you thought there was an art to this?… Read the rest

Mark Dennehy in 06 Dec 2017 1 Comment

Toothy prep

Baby blanket chest Side Table Tools

Woodworking

Well, that decided where to start for the evening I guess. I ripped the panels first, and then changed the blade because it was just wandering too much, and then cut the rails to approximate thickness and the stiles to rough thickness and straightened.

Before:

After:

Bunch of small thin stock gathered as well. I’ll leave that dry on its own, see if it stays unwarped.

Then on to cleaning up edges on the panels.

And then checking to see if I have enough width on the panels…

Yup, all good. Just resaw those and it’ll be grand.

Then on to cleaning up the faces of the rails and stiles. Started on the stiles and on the first pass it became obvious there was a problem.

Even a close-set #5 left huge tearout, really nasty stuff.… Read the rest

Mark Dennehy in 05 Dec 2017 3 Comments

Stochastic Geometry

mark.dennehy

Standing upright

Resawing sucks.

Toothy prep