Home / Tag "lathe stand"

First chips!

3D PrintingShedWoodturning
More
Woodworking

Storm Denis, schwarm denis.

Simple 19mm pine footing for the lathe stand. Lap joints and glue at the corners. Got the feet as centered as I wanted them, then pencil around them and since the front two could overhang the bench safely, I could drill, countersink and screw up from beneath into the legs.

Then flipped it over onto the floor, and drilled, countersunk and screwed the other two. And that’s the stand complete, so at that point I stuck it outside for a few minutes during a break in the rain and moved stuff around and then wrestled it back inside.

And it fits! I mean, yes, it’s built to fit but still, nice to see 😀

The back corner is a tad close to the drills and such, but it turns out it’s just far enough away to be usable.… Read the rest

Read More
Mark Dennehy in 1 Comment

Almost ready to start turning

3D PrintingShedTools
More
WoodturningWoodworkingWorkbench

Two more nights in the woodturning class since last time. And I’m still not dead, which has surprised everyone.

Lay off the jokes, it’s a dibber. You stick it in the ground, wiggle it about to make a hole, drop in a daffodil bulb. The burn lines indicate how far down you’ve gone becuase that matters for some bulbs (specifically, the ones you want to not rot in the ground). Sanding on a lathe btw, is immensely fun, because you just hold the sandpaper and the lathe does the work. Holy hell is that better than sanding a resin&walnut desk….

And then this week….

Yes, that thing was a branch in Marley Park the morning before. Green wood. Fantastic to work with, like cutting cheddar cheese. Woodcarving videos of green wood are now ruined for me, those lads are just cheating 😀

Tapered head…

Turn a handle and put in some burn lines for fun…

Check the fit, refine it a bit…

And that’s it done.… Read the rest

Read More
Mark Dennehy in No Comments

Lathe stand

ShedWoodturningWoodworking

Slow week for the shed, not much time spent there. The lathe stand is the thing at the moment, have to get that built so I can get the lathe out of the hallway, and start to tidy the shed back up again. So the plan is to make something that is a bit minimalist instead of overbuilding the carp out of it. Most of the designs I came across were basically an inverted T with the lathe mounted on top and all the weight available piled on the bottom in the form of sandbags, bricks, concrete and so on, which is okay, but if I do that I won’t have room to get into the shed afterwards and it’d still be tippy even if I bolted the thing to the floor because I’m a bit taller than the average 1930s person and so the centers of the lathe should be 47″ above the floor.… Read the rest

Read More
Mark Dennehy in 2 Comments