Home / Tag "hand tools" (Page 20)

Masochism…

Bandsaw BoxesWoodworking

…is deciding to make a batch of bandsaw boxes for your son’s school’s xmas bazaar thingy, while in a shed that’s too small, with a bandsaw that’s not really up to the task, and a sanding arrangement that… well, more on that in a moment.

I mean, I don’t even keep anything other than 4/4 material on hand, thicknessing anything else down to the normal 3/4 width you see in furniture is just too much work by hand (though I do need to get some 8/4 stuff soon for a piece’s legs). So it’s lamination city…

Something is missing….

Ah, there they are. Literally every clamp I have (bar the 5′ cast iron ones that are slowly rusting away outside, accusingly. I’ll get to them this xmas and sort them out, honest).… Read the rest

Read More
Mark Dennehy in No Comments

Guides and tests

Side TableWoodworking

Well, made a dog’s breakfast of the bandsaw boxes I was playing at. Couldn’t make the turn needed and the blade came out the side of the blank. Oh well. Now I have two paperweights (and one successful box, out of four blanks). I’ve ordered a one-eighth inch blade off Tuffsaws, that should get here next week and I can try again. I’ll prep new blanks tomorrow for that.

Bit of a waste, those 🙁

Meanwhile the older replacement y-lever for the #5½ arrived and I replaced the existing y-lever with it and it’s been a lot nicer to work with since. And no surprise. This is what the more modern y-lever looks like, two pressed steel parts riveted together:

Unfortunately, the rivet on mine isn’t as tight as it should be and even glue didn’t stop the inevitable end result (and if you’re thinking this would interfere with setting the plane you’d be right):

Meanwhile, back on the main project…

The bridle joints involved are a bit of an oddity; nobody really cuts them often enough to get good at them, at least not off the saw, so these are Richard McGuire’s basic jigs for helping to cut them (and the test sticks in the backgrounds, just a spare bit of poplar that I’m using up).… Read the rest

Read More
Mark Dennehy in 4 Comments

Progress and mucking about

GeneralSide TableTools
More
Woodworking

So I figured I’d start by playing with the new toy and taking some test cuts.

The blade runs sort-of true. Well, I wasn’t expecting laser levels of perfection here, but the guides really are letting things down. The lower thrust bearing can’t be backed off readily to adjust it so it’s not poking the blade out of true, which is disappointing. And I really can’t run this thing without dust extraction or the whole lower case clogs up and the bearing itself locks up. Well, I knew machinery would counter its speed by increasing the amount of faffing about needed to support it. This is why you usually mount this stuff permanently where you have room to manoeuvre around it. But again, 8’x6′ shed, no room to think, let alone manoeuvre, so we need to make do.… Read the rest

Read More
Mark Dennehy in No Comments