Stochastic Geometry

So the last part of the build is the lid. Though if I had to do this over, I think I’d start with the lid, or at least with prepping its parts because that can set the dimensions of the rest of the parts (but in this case, I had a preset idea for what the contents of the chest would be so that dictated everything). I had a nice piece of oak for the lid but it wasn’t wide enough to act as a single-piece lid (since the lid’s not an inset door, you can do the one-piece bit if it’s not likely to warp – so quartersawn or riven stuff). So it’s frame and panel time again.

First though, need to move the chest off the workbench while I work on the lid.… Read the rest