Home / Tag "dovetails" (Page 3)

Starting to finish

Desk ShelfFinishingLocker
More
StringingWoodworking

So time to take the shelf out of the clamps and see if it’s okay…

holds breath…

That’s not too bad from the front 🙂
Different story from the back mind…

Urgh those dovetails. There will have to be some remediation work there. At least the white inlay bits worked reasonably well (you just can’t do dovetails from end to edge like that if there’s more than one tail, the short grain on the pin means it always breaks off, so I deliberately broke off the pins and replaced them with some sycamore chunks).

Okay. Time to start finishing. I could keep trying to touch this up for ages and never finish 🙁

Going for a simple finish this time, just some thin coats of osmo and buffing it out.… Read the rest

Read More
Mark Dennehy in 2 Comments

Glue-up part two

Desk ShelfLockerStringing
More
Woodworking

The resawn beech from yesterday is holding up well…

But never mind that, time to focus on the glueup from yesterday. It went reasonably well despite the fiddliness of the clamping.

They don’t look even from that angle, but they are:

There’s some squeeze-out and the join needed some fettling to get it properly smooth, and I suspect I’ll be running round the piece with a chisel checking arises before finishing, but it’s not too bad.

It’ll be interesting to see it with finish on. But today’s task is the final glue-up so I did a dry-fit and some inevitable tweaking and then did a dry rehearsal and then prepped to glue up:

The final glue-up was almost calm right up until the end when I realised I needed to clamp the dovetails as well and I had nothing on the front to clamp against and had to rig something using a third sash clamp and some heath robinson nonsense…

We’ll see how that went tomorrow…… Read the rest

Read More
Mark Dennehy in 2 Comments

Done…

Bandsaw BoxesDesk ShelfFinishing
More
Wall CupboardWoodworking

Next year, we’re rescheduling christmas. End of discussion.

This year, Christmas Eve started with a quick run to woodies for small brass hinges. Then to the shed and…

Awkward planing setup needed to plane the outside of the carcass (the inside was planed before glue-up). I know it doesn’t look too awkward, but that’s because we need to zoom out a little and let you see where you’re standing when working…

The spot is that one there behind that small green case on the floor, between the bench and the tumbledrier but not past the leg of the bench because there’s a lot of small boards there that didn’t go in the main wood store. The joy of a small shed…

The downside is that you can’t really move when planing, so it’s all armwork rather than legwork.… Read the rest

Read More
Mark Dennehy in 2 Comments