Testing

GeneralShedSidecar Cot
More
Woodworking

Last few days have mainly been testing; both in the “new toys and new ideas” sense and in the “three days off from food poisoning and losing ten pounds in the process” sense. Happily, I only have photos from the former.

I did get some work done on the cot before the enforced break set in, the biggest and trickiest of the mortise and tenon joints is now all fettled and the slats have been picked out and I’m working on the spacing for them. But apart from that, it’s been small stuff only.

I was wondering about the exposed end grain bits there will be in the cot and then I saw this approach by Brian Halcombe :

It’s downright pretty. I wondered if I could do that so I sharpened my smallest gouge and dug into a scrap bit of walnut:

Well, the idea works at least.… Read the rest

Read More
Mark Dennehy in 3 Comments

Lists

Sidecar CotWoodworking

So, new years are all about lists and I figured I’d go through the last one…

  • Rip the top panel to width.

Yeah, that’s done. What I missed was that when I cut that top panel down to length, I cut it to the shoulder-to-shoulder length, not the overall length, so it was now too short. The single biggest part in the entire piece and it didn’t fit. It turns out that in the shed, they can hear you scream.

So, new item:

  • Add spare piece of walnut to top stretcher on drawer end, matching grain, to fill the gap left by the top panel being too short.

And that’s now done as well.

  • Add the rebate and bevel to the top panel.

Done, and I’ve had to make small cut-outs at the corners to allow for the vertical posts as well.… Read the rest

Read More
Mark Dennehy in No Comments

Testing…

WoodworkingWorkbench

Finished the last of the crossbars today, checked the fit and fettled a bit, and then thought I’d try test-assembling the base…

That’s the bending jig; it was MDF so I considered it disposable (I must recover the screws from it now that I think about it). And the light was just going, hence the odd lighting. This really is too large to assemble on the bench; I’ll have to assemble it on this. It’s worse for wear thanks to moisture, but pffft. It’s MDF. It’s for the bin anyways.

Mental note, next time do this in daylight; can you see the deliberate error? 😀 I put the top bar at the end closest to the camera in upside down by mistake and got almost an inch of misalignment at the top, which gave me a moment’s pause until I figured out what I’d done.… Read the rest

Read More
Mark Dennehy in No Comments