Lid and base

Baby blanket chestNew Toys!Tools
More
WoodcarvingWoodworking

May day bank holiday weekend. Going to try to finish up the box. First up, the lid, which I already have a piece prepped for:

Also, bought two new tools, this time off aliexpress.com rather than ebay.co.uk. You wouldn’t think of aliexpress for hand woodworking tools, but there are a few…

A clone of the shinwa saddle mitre square, and…

A marking gauge. Works like a normal marking gauge on the right hand side there; on the left hand side, you have two contact points that rotate, so you can mark a line “parallel” to a curved edge. Neat.

Oh, and I want to try that resin experiment again, but this time seal the oak grain so the resin can’t wick into it.

The lid’s been sitting around for a while.… Read the rest

Read More
Mark Dennehy in 6 Comments

All sides now…

Baby blanket chestWoodcarvingWoodworking

So, four day weekend so almost six hours in the shed 😀
Got the last of the background removal done…

Mix of hand pressure on the gouges and whacking the everloving stuffing out of them with a mallet, and trying to get the background down about 4-5mm or so relatively uniformly across the background. Then to eliminate the unevenness, stippling!

Basically, lots of spikes on the end of a punch, and thwack it with a lump hammer lots and lots of times until…

And then just douse it in boiled linseed oil to show it all up. There are some decorative punches as well, just five or six on the panel.

BTW, Peter Follansbee makes all this look easy. This is a LIE. HE LIES. The git 😀

Front, back, and both sides now carved and all bar the front wiped down with BLO.… Read the rest

Read More
Mark Dennehy in No Comments

Spring cleaning time…

ShedWoodworking

So, after the whole resin-casting-a-mug thing, it’s fair to say that the shed was in need of a cleanup…

Turns out, sanding resin will actually leave a bit of residue. Also, the shavings are starting to pile up again…

And the bandsaw is getting buried…

And the shop vac wasn’t actually vac-ing much either. So I started there, and checked the drum for the vortex separator, but it wasn’t even a tenth full, so I took out the filter from the shop vac…

And sure enough, there’s the problem:

Totally clogged with fines. So out with a stanley knife, and scrape all the dust off because I don’t have a spare filter right now. Took about five minutes, and it’s definitely not perfect but it’ll hold till I get a new one:

Then dustpan and brush to fix the floor:

And then wipe down the planes, and dip the handles of all the chisels in a jar of BLO and wipe down the handle and blade (after getting rid of all the surface rust with a scotchbrite pad), and all the marking gauges and so on:

And clean up the bandsaw and restack everything and wax the table…

Yeah, it’s not exactly tidy, but you try putting a litre in a pint pot sometime.… Read the rest

Read More
Mark Dennehy in No Comments