Home / 2018 / January (Page 3)

Too many inches

Baby blanket chestToolsWoodcarving
More
Woodworking

Quite a bit of time in the shed today, so made some progress (there being a nearby deadline, this is a good thing). Started by cutting a side rail’s tenons, then marking off the other side rails from it (same as for the long rails).

I wanted to keep using the offset shoulder idea, but rather than gauging it by eye, which I can’t do yet, or sawing on one or the other side of the line, which I also have trouble doing, I decided to just mark out the shoulders and cut to the line. So I marked off the show face shoulder, ran the line round with the square to the back side, and then marked out 5mm or so of the line on the back side, then put a ruler on the line and butted the square up against that.… Read the rest

Read More
Mark Dennehy in 3 Comments

Offset shoulders

Baby blanket chestToolsWoodworking

Started off with a quick check of something for Ralph who’d had a minor mishap over on Accidental Woodworker with his #044.

Ouch. Cast part weakness strikes again 🙁

For Ralph, my #044’s rods are square to the fence to within 0.05mm (my thinnest feeler gauge):

And square to the skate to the same tolerance:

And there are gaps around the rod in the fence holes. It’s hard to gauge how much by because my feeler gauges are flat and don’t cope with tight radii well, but it looks somewhere around 0.1mm.

There is a discernible line around the rod in the plane body, but no discernible gap and I can’t get even the tip of the 0.05mm feeler gauge in there.

Incidentally, I normally have the fence rods a few inches proud of the body of the plane like that because its spot on the wall sees it stay in place using both the rods and the secondary fence on the plane:

Hope that helps Ralph.… Read the rest

Read More
Mark Dennehy in 2 Comments

Nocturne

Baby blanket chestWoodworking

Nocturne because all day today I was Chopin’, see?

Yeah, well. It was funny in my head.

Anyway, today was mortice day.

That’s my normal way of cutting mortices. The piece is over (or close to) the vice leg (which is thicker than the other workbench legs for just this kind of reason), rather than held in the vice because that way you don’t have to crank on the vice until the steel creaks so your piece doesn’t slip while you’re wailing on it. The holdfast method is just better, faster, and causes less hassle. The clamp and other pieces of wood only come out when the mortice is close enough to the edge that I worry about blowout; and really I’d like to get one of those traditional dual screw woodworking clamps to use instead.… Read the rest

Read More
Mark Dennehy in No Comments