2017 – Page 7 – Stochastic Geometry

Home / 2017 (Page 7)

Another interloper

No work in the shed last night, on account of aches, pains, freezing despite sitting beside the fire, and the usual pre-cold fun stuff. I crashed, went to bed, worked from home today (yes, you can type while under a duvet), and by afternoon was feeling somewhat more human.

So this evening when junior and mommy got back home, junior and I opened the large boxes from FFX and Rutlands that arrived over the last day or two and dragged the latest interloper to the shed…

It’s… slightly larger than anticipated. But not by too much. What it was was loud. The specs said under 85dbA, the meter says 96dbA. And when you start sanding, it peaks somewhere around 106dbA – 3dBA louder than the dang bandsaw. Hmmm.… Read the rest

Mark Dennehy in 29 Nov 2017 1 Comment

Sounds okay

Baby blanket chest Shed Side Table

Tools Woodworking

Couple of bits and bobs arrived in the post today:

Some brass-plated hinges for the next project, a silicone hose adapter to try to improve dust extraction from the bandsaw:

Beats a spring clamp and a bungee cord.
And this little doodad as well:

I’ve been wondering how bad the noise from the shed actually is for the neighbours you see. Enter the Uni-T UT353, a cheap little noise meter from Shenzen. And after a wee bit of experimentation, some pleasant results – the loudest thing with the bandsaw running is the vacuum cleaner that does dust extraction. It’s 87dbA in the shed itself with the door shut; 65dbA just outside on the decking; and it’s 55dbA back on the patio by the back door (for reference, it’s 65dbA inside the kitchen with junior watching Rescue Bots and the other usual sounds of life).… Read the rest

Mark Dennehy in 27 Nov 2017 No Comments

Legs

Side Table Woodworking

Okay, winter’s here.

And of course that leaves us with the eternal question, why is it always the show face that chips out?

But at least the CA glue did the trick. And on with cutting more leg joints and then apron joints and then test fittings…

Chop, chop, chop…

Swear, swear, swear…
And then recut the mortice so the leg comes up above the apron to be trimmed.

At least the joints are tight enough. I can just about get a 0.10mm feeler gauge into parts of the joints when they’re set; I can’t get the 0.20mm one in.

So that’s all the leg joints cut, now, time for the halving joint for the aprons.

Looks okay, it’s the right way round at least (don’t have legs going up on one side and down on the other…)

But it’s a bit gappier than I’d like.… Read the rest

Mark Dennehy in 26 Nov 2017 No Comments