Okay then…
…let’s see if he was right.
Just not a very productive Sunday really. Checked my squares, found one is so not square that I threw away the crosspiece and I’ll use it as a straightedge from now on.
Then got on with building the jig. Laid out the geometry (a 10.3″ radius curve gives a 12″ radius curve and 15 degrees of springback).
Shop cat is somewhat critical of the layout…
Laminating MDF to make a drying form (which will have the 12″ radius and the walnut gets clamped to this for a week after it’s had a day or so on the bending jig to cool).
Lots of laminated MDF and 2×4 chunks. This is when you not only have insufficient clamps but also insufficient space to put the drying bits 😀
I thought it was a bit of a gimmicky thing when I bought it, but those silicone glue brushes work damn well.… Read the rest
Problem with knowing you have N slats to get prepped is that that’s a nice countdown type task, just doing the same thing over and over with a nice number ticking away. Then it hits zero and unless you’re prepped, you have no idea what you’re doing next. Which is where last night’s shed time went. I tried out the new arno burnisher I got for the card scraper (Chris Schwartz was right, get one) and put away some new small c-clamps at least temporarily, I played with the new lens for the camera (just a basic kit lens doing 18-55mm because if you’re in a six foot deep shed taking photos of a five foot wide bench, a 40mm prime lens is just not helpful).
But all I did on the crib was prep one board I had set aside for the frame, plane it to smooth (not square) and rip it in half to give me two 2-and-a-bit inch wide rough blanks. … Read the rest